The manual states to use a 9/32 drill bit and it fits the led and valet switch very snug. I mounted it just to the left of the steering wheel and to the right of the cup holder and ran the wire under the dash. I originally wasn't going to mount te valet switch since I won't be using it much after the initial install since this is only a keyless entry system, but I decided to just install it as having to connect and disconnect it if I ever needed to use it was a pita. The wire isn't long enough to reach to the middle of the windshield like most alarm systems so I settled with above the drivers seat. I ran the LED wire under the dash over to the A pillar, up the A pillar and I installed it in the roof flashing down onto the windshield in front of the drivers seat. Drilling the crews was extremely easy and it makes it easily accessible if I ever need to disconnect it for any reason. It is just to the right of the OBD connector and does not get in my way. I decided to use self tapping screws and mount it on the panel below the steering wheel just above the clutch. Here is an image of the wires you need to use and what each one is used for:įirst choose where you want to mount the module. I will be updating this DIY with some pics of my install next week, but for now I have all of the wire images that you need to do this install.ġ/4" ring/loop connectors for 18-22 gauge wireįemale 1/4" connector for 18-22 gauge wireĤ self tapping screws (can't remember the diameter that fits, but preferably the smallest you can get at a hardware store YW member DanQ apparently had a full DIY done for the 211HV system but it is no longer an active link. Most of this information is floating between 2 or 3 threads that are more specific to remote starters and there was an error on one of the threads that hadn't been updated. I would not have been able to make this DIY is it wasn't for his vast electrical knowledge and great images of the connectors. The vast majority of the images in this DIY are from YW member CTScott as well as the majority of information. The following information will be specific to the Viper 211HV keyless entry, but it will be virtually the same for the majority of other keyless entry systems and even remote start or alarm systems.
I wanted to put all of the info in one place so that someone could purchase a keyless entry system and install it within a couple hours using this guide and only this guide.
0 kommentar(er)
